autometer

Replacement wiring harness for Elite pressure only gauges. Not for use with boost/vacuum gauges. Replacement wiring harness for Elite temperature gauges. Not for use with EGT gauges.

Autometer Replacement Wideband Air/Fuel O2 Pro Plus Sensor

For tachometers with remote Memory plate. Will work with new recessed switch design.Installation Instructions

AutoMeter RPM Chip Kit 5.6K RPM For Pro Shift Incl. 5.6K 5.8K 6.0K 6.2K & 6.4K

AutoMeter RPM Chip Kit 8K RPM For Pro Shift Incl. 8K 8.2K 8.4K 8.6K & 8.8K

AutoMeter RPM Chip Kit 9K RPM For Pro Shift Incl. 9K 9.2K 9.4K 9.6K & 9.8K

This fully potted, weatherproof module can be wired to ground / kill switch terminal magneto ignition systems to provide a conventional 12V square wave signal which can be utilized by AutoMeter tachometers and RPM activated devices.

This compact and easy to install module will allow you to easily adapt AutoMeter tachometers and shift lights and many other aftermarket RPM-based devices on your alternator-equipped diesel or non-standard ignition gasoline engine. Equipped with a sensor which is mounted to the alternator casing,...

AutoMeter RPM Switch / Rev-Limiter Pro-Control For Ext. Coil Magneto Interrupter

AutoMeter RPM Switch / Rev-Limiter Pro-Control For Standard Ignition Interrupter

This solid state fluid pressure sensor from AutoMeter features a -4AN male fitting allowing for direct connection to racing lines without additional adapters being required, reducing system weight, and complexity.

This solid state fluid pressure sensor from AutoMeter features a -4AN male fitting allowing for direct connection to racing lines without additional adapters being required, reducing system weight, and complexity.

These pressure transducers are designed to measure fluid pressure in relation to ambient pressure. Compatible with a wide array of common automotive fluid types including but not limited to water / coolant, gasoline, ethanol, methanol, diesel, air, nitrous oxide, oil, and brake fluid. Constructed...

This unique solid state low pressure fluid sensor from AutoMeter features a unique vent design to allow the sensor to rapidly equalize reference pressure to provide accurate readings immediately after re-connection to the harness plug. This is an essential upgrade for a team who...

These pressure transducers are designed to measure fluid pressure in relation to ambient pressure. Compatible with a wide array of common automotive fluid types including but not limited to water / coolant, gasoline, ethanol, methanol, diesel, air, nitrous oxide, oil, and brake fluid. Constructed...

100 PSI Pressure sensor and 8ft cable kit for Ultimate DL tachometers

These replacement temperature sensors are designed for use with AutoMeter gauges produced prior to 1995 which are visually identifed by their light blue case and a distinctive black mask on the lens covering the pointer hubs. For current generation instruments, please see models #2258,...

These replacement temperature sensors and included 3/8" and 1/2" adapters are designed for use with AutoMeter gauges produced prior to 1995 which are visually identifed by their light blue case and a distinctive black mask on the lens covering the pointer hubs. For current...

All shift lights plug directly into Digital Shift Controller or AutoMeter tachometer with dedicated shift light connector

Lightweight single stage shift light with blinking over-rev indication. Requires RPM signal generator for programming (not included). Single button RPM capture for shift light activation point. RACE ONLY, not intended for street applications.Installation Instructions